Low Battery Voltage

The battery needs charging or there is a bad connection to the battery. Check the connections to the battery. If the connections are good, try charging the battery.

Motor Disconnected

The motor has a bad connection. Check all the connections and leads between the motor and the S-drive Check the position of the freewheel switch.

Motor Wiring Trip

The motor has a short circuit to a battery. Check all the connections and leads between the motor and the battery.

Freewheel Switch Trip

The freewheel switch is activated or the manual brake disengagement mechanism is operated. Check the position of the switch or lever and all connections between the switch and the S-drive.

Not Used

Charger Connected

The S-drive is being inhibited from driving. Inhibit 2 is active. This may be because the battery charger is connected or the seat is not in the driving position.

Throttle Trip

A throttle trip is indicated. Make sure that the throttle is in the neutral position before switching on the scooter.

Possible Control System Trip

A control system trip is indicated. Make sure that all connections are secure.

Solenoid Brake Trip

The parking brakes have a bad connection. Check the parking brake and motor connections. Make sure all the system connections are secure.

High Battery Voltage

An excessive voltage has been applied to the S-drive. This is usually caused by a poor battery connection. Check the battery connections.

Control System in Sleep Mode

The S-drve has entered sleep mode. Switch the scooter off and then on again.

Charge Step

The batteries are charging.

Throttle Displaced

The throttle has been displaced whilst the scooter is being switched on. Place the throttle in the neutral position and turn the scooter off and on again.