Skip to main content
Submitted by britto on August 22, 2025

HOME ONLINE DIAGNOSTICS FLASH CODE LIST

SERVICE CENTER

Pilot+ Flash Codes

Low Battery Voltage

Low Battery Voltage

The battery needs charging or there is a bad connection to the battery. Check the connections to the battery. If the connections are good, try charging the battery.

Left Motor Disconnected

Left Motor Disconnected

The left motor* has a bad connection. Check all the connections and leads between the left motor and the Pilot.

Left Motor Wiring Trip

Left Motor Wiring Trip

The left motor* has a short circuit to a battery. Check all the connections and leads between the left motor and the battery.

Right Motor Disconnected

Right Motor Disconnected

The right motor* has a bad connection. Check all the connections and leads between the right motor and the Pilot.

Right Motor Wiring Trip

Right Motor Wiring Trip

The right motor* has a short circuit to a battery. Check all the connections and leads between the right motor and the battery.

Charger Connected

Charger Connected

The wheelchair is being prevented form driving by an external signal. The exact cause will depend on the type of wheelchair you have, one possibility is the battery charger is connected.

Possible Joystick Trip

Possible Joystick Trip

A joystick trip is indicated. Make sure that the joystick is in the center position before switching on the Pilot.

Possible Control System Trip

Possible Control System Trip

A control system trip is indicated. Make sure that all connections are secure.

Solenoid Brake Trip

Solenoid Brake Trip

The parking brakes have a bad connection. Check the parking brake and motor connections. Make sure the connections to the Pilot are secure.

High Battery Voltage

High Battery Voltage

An excessive voltage has been applied to the control system. This is usually caused by a poor battery connection. Check the battery connections.

Commonly Seen Informational Flash Codes

Control System in Sleep Mode

Control System in Sleep Mode

The control system has entered sleep mode. Switch the Pilot off and then on again.

Joystick Displaced

Joystick Displaced

The joystick has been displaced while the Pilot is being switched on. Place the joystick in the center position and turn the Pilot off and on again.

Control System Locked

Control System Locked

This indicates that the Pilot has been locked and cannot be driven. Unlock the Pilot.

* If the programmable parameter, Motor Swap has been enabled, then left and right hand references in this table will need transposing.

If the problems persist after you have made the checks described above please contact your service agent.

print